Turbidity analyser
Multi-beam of RD measurement technology to compensate for the impace of ambient light, dirt and component aging.
Multi-point calibration to ensure accuracy within the measuring range.
A variety of variables output, intelligent control systems such as current and relays.
The sensor can be configured to air purge device, controlled by the transmitter to self-clean.
A variety of installation methods such as immersion, pipe plug-in etc...
Water treatment plant: Sedimentation tanks
Paper mill: Pulp concentration
Coal washing plant: Sedimentation tanks
Electricity: Mortar sedimentation tanks etc.
Sewage treatment plant: Inlet and outlet, aeration tanks, return sludge, primary sedimentation tank, secondary sedimentation tank, concentration tank, sludge dewatering etc.
|
Item |
Turbidity Analser |
|
Transmitter |
Technical Parameters:
Measuring Range: Activated sludge, 0 ~30g/L
Silica, 0~100 g/L
Display: LCD
Units of Measurement: g/L and mg/L(Optional)
Resolution: 0.01%
Accuracy: +-1.0%FS
Repeatability: +-1.0%
Power: < =15 W
Analog Output: 4~20mA, load 750Ω
Switch Output: 2 relays, capacity 220VAC/2A
Power Supply: AC220V+-10%
|
Sensor
|
Sensor
Material: 316stainless steel
Cable: shielded cable
Installation: Immersion, pipe plug-in
Process Connection: ZG1
Dimensions: Φ 50*96mm
Medium Pressure: < =3 bar
Signal Cable: 10M(standard configuration)Can be extended
Degree of Protection: IP68
Operating Temperature: Sensor: -20~60C |
